TP-Link JetStream TL-SG3424P - Lldp Tlv-Select; Lldp Med-Status

194
lldp tlv-select
Description
The lldp tlv-select command is used to configure TLVs to be included in
outgoing LLDPDU. To exclude TLVs, please use no lldp tlv-select command.
By default, All TLVs are included in outgoing LLDPDU.
Syntax
lldp tlv-select [port-description] [system-capability] [system-description]
[system-name] [management-address] [port-vlan-id] [protocol-vlan-id]
[vlan-name] [link-aggregation] [mac-phy] [max-frame-size] [power] [all]
no lldp tlv-select [port-description] [system-capability] [system-description]
[system-name] [management-address] [port-vlan-id] [protocol-vlan-id]
[vlan-name] [link-aggregation] [mac-phy] [max-frame-size] [power] [all]
Command Mode
Interface Configuration Mode（interface ethernet / interface range ethernet）
Example
Exclude “management-address” and “port-vlan-id” TLVs in LLDPDU outgoing
from port 8:
TP-LINK(config)# interface ethernet 8
TP-LINK(config-if)# no lldp tlv-select management-address port-vlan-id
lldp med-status
Description
The lldp med-status command is used to enable the port’s LLDP-MED status.
Enable the port's LLDP-MED status, and the port's Admin Status will be
changed to Tx&Rx. To disable LLDP-MED status, please use no lldp
med-status command.
Syntax
lldp med-status {enable }
no lldp med-status
Parameter
enable —— Enable the port's LLDP-MED status, and the port's Admin Status
will be changed to Tx&Rx.
Command Mode