TP-Link JetStream TL-SG3424P - Flow-Control; Negotiation

109
Interface Configuration Mode（interface ethernet / interface range ethernet）
Example
Disable Ethernet port3:
TP-LINK(config)# interface ethernet 3
TP-LINK(config-if)# shutdown
flow-control
Description
The flow-control command is used to enable the flow-control function for a port.
To disable the flow-control function for this corresponding port, please use no
flow-control command. With the flow-control function enabled, the Ingress
Rate and Egress Rate can be synchronized to avoid packets drop in the
network.
Syntax
flow-control
no flow-control
Command Mode
Interface Configuration Mode（interface ethernet / interface range ethernet）
Example
Enable the flow-control function for Ethernet port 5:
TP-LINK(config)# interface ethernet 5
TP-LINK(config-if)# flow-control
negotiation
Description
The negotiation command is used to configure the Negotiation Mode for an
Ethernet port. To return to the default configuration, please use no negotiation
command.
Syntax
negotiation { auto | 10h |10f |100h |100f |1000f }
no negotiation
Parameter
auto —— Auto negotiation (default).