TP-Link JetStream TL-SG3424P - Radius Response-Timeout; Show Dot1 X Global

77
Command Mode
Global Configuration Mode
Example
Configure the shared password for the switch and the accounting servers as
tplink:
TP-LINK(config)# radius accounting key tplink
radius response-timeout
Description
The radius response-timeout command is used to configure the maximum
time for the switch to wait for the response from the RADIUS authentication and
the accounting server. To restore to the default value, please use no radius
response-timeout command.
Syntax
radius response-timeout time
no radius response-timeout
Parameter
time ——The maximum time for the switch to wait for the response before
resending a request to the supplicant., ranging from 1 to 9 in second. By default,
it is 3.
Command Mode
Global Configuration Mode
Example
Configure the maximum time for the switch to wait for the response from the
RADIUS authentication and the accounting server as 5 seconds:
TP-LINK(config)# radius response-timeout 5
show dot1x global
Description
The show dot1x global command is used to display the global configuration of
801.X.