TP-Link JetStream TL-SG3424P

To Next Page

To Previous Page

XII

show cluster neighbour........................................................................................................205

show cluster ntdp global ......................................................................................................205

show cluster ntdp port-status...............................................................................................206

show cluster ntdp device .....................................................................................................206

show cluster manage role....................................................................................................207

Main Page

Default Chapter3
- Table of Contents3
Preface14
Chapter 1 Using the CLI17
- 1.1 Accessing the CLI17
  - 1.1.1 Logon by a Console Port17
  - 1.1.2 Logon by Telnet19
- 1.2 CLI Command Modes21
- 1.3 Security Levels23
- 1.4 Conventions24
Chapter 2 User Interface25
- Enable25
- Enable Password25
- Disable26
- Configure26
- Exit26
- End27
Chapter 3 IEEE 802.1Q VLAN Commands28
- Vlan Database28
- Vlan28
- Interface Vlan29
- Description29
- Switchport Type30
- Switchport Allowed Vlan30
- Switchport Pvid31
- Switchport General Egress-Rule31
- Show Vlan32
- Show Interface Switchport32
Chapter 4 MAC VLAN Commands33
- Mac-Vlan Add33
- Mac-Vlan Remove33
- Mac-Vlan Modify34
- Show Mac-Vlan34
Chapter 5 Protocol VLAN Commands35
- Protocol-Vlan Template35
- Protocol-Vlan Vlan35
- Show Protocol-Vlan Template36
- Show Protocol-Vlan Vlan36
Chapter 6 Voice VLAN Commands38
- Voice-Vlan Enable38
- Voice-Vlan Aging-Time38
- Voice-Vlan Priority39
- Voice-Vlan Oui39
- Switchport Voice-Vlan Mode40
- Switchport Voice-Vlan Security41
- Show Voice-Vlan Global41
- Show Voice-Vlan Oui41
- Show Voice-Vlan Switchport42
Chapter 7 GVRP Commands43
- Gvrp43
- Gvrp (Interface)43
- Gvrp Registration44
- Gvrp Timer44
- Show Gvrp Global45
- Show Gvrp Interface46
Chapter 8 LAG Commands47
- Interface Link-Aggregation47
- Interface Range Link-Aggregation47
- Link-Aggregation48
- Link-Aggregation Hash-Algorithm49
- Description49
- Show Interfaces Link-Aggregation50
Chapter 9 LACP Commands51
- Lacp System-Priority51
- Lacp Admin-Key51
- Lacp Port-Priority52
- Show Lacp Interface52
- Show Lacp System-Priority53
Chapter 10 User Manage Commands54
- User Add54
- User Remove55
- User Modify Status55
- User Modify Type56
- User Modify Password56
- User Access-Control Disable57
- User Access-Control Ip-Based57
- User Access-Control Mac-Based58
- User Access-Control Port-Based58
- User Max-Number59
- User Idle-Timeout59
- Show User Account-List60
- Show User Configuration60
Chapter 11 Binding Table Commands62
- Binding-Table User-Bind62
- Binding-Table Remove63
- Dhcp-Snooping63
- Dhcp-Snooping Global64
- Dhcp-Snooping Information Enable65
- Dhcp-Snooping Information Strategy65
- Dhcp-Snooping Information User-Defined66
- Dhcp-Snooping Information Remote-ID66
- Dhcp-Snooping Information Circuit-ID67
- Dhcp-Snooping Trusted67
- Dhcp-Snooping Mac-Verify68
- Dhcp-Snooping Rate-Limit68
- Dhcp-Snooping Decline69
- Show Binding-Table69
- Show Dhcp-Snooping Global70
- Show Dhcp-Snooping Information70
- Show Dhcp-Snooping Interface71
Chapter 12 ARP Inspection Commands72
- Arp Detection (Global)72
- Arp Detection Trust-Port72
- Arp Detection (Interface)73
- Arp Detection Limit-Rate73
- Arp Detection Recover74
- Show Arp Detection Global75
- Show Arp Detection Interface75
- Show Arp Detection Statistic75
- Show Arp Detection Statistic Reset76
Chapter 13 Dos Defend Command77
- Dos-Prevent77
- Dos-Prevent Type77
- Show Dos-Prevent78
Chapter 14 IEEE 802.1X Commands79
- Dot1X79
- Dot1X Auth-Method79
- Dot1X Guest-Vlan80
- Dot1X Quiet-Period81
- Dot1X Timer81
- Dot1X Retry82
- Dot1X(Interface)82
- Dot1X Guest-Vlan83
- Dot1X Port-Control83
- Dot1X Port-Method84
- Radius Authentication Primary-Ip85
- Radius Authentication Secondary-Ip85
- Radius Authentication Port86
- Radius Authentication Key86
- Radius Accounting Enable87
- Radius Accounting Primary-Ip88
- Radius Accounting Secondary-Ip88
- Radius Accounting Port89
- Radius Accounting Key89
- Radius Response-Timeout90
- Show Dot1X Global90
- Show Dot1X Interface91
- Show Radius Authentication91
- Show Radius Accounting92
Chapter 15 Log Commands93
- Logging Local Buffer93
- Logging Local Flash93
- Logging Clear94
- Logging Loghost95
- Show Logging Local-Config95
- Show Logging Loghost96
- Show Logging Buffer Level96
- Show Logging Flash Level97
Chapter 16 SSH Commands98
- Ssh Server Enable98
- Ssh Version98
- Ssh Idle-Timeout99
- Ssh Max-Client99
- Ssh Download100
- Show Ssh100
Chapter 17 SSL Commands101
- Ssl Enable101
- Ssl Download Certificate101
- Ssl Download Key102
- Show Ssl102
Chapter 18 Address Commands104
- Bridge Address Port-Security104
- Bridge Address Static105
- Bridge Aging-Time105
- Bridge Address Filtering106
- Show Bridge Port-Security107
- Show Bridge Address107
- Show Bridge Aging-Time108
Chapter 19 System Commands109
- System-Descript109
- System-Time Gmt109
- System-Time Manual110
- System-Time Dst110
- Ip Address111
- Ip Management-Vlan112
- Ip Dhcp-Alloc112
- Ip Bootp-Alloc112
- Reset113
- Reboot113
- User-Config Backup114
- User-Config Load114
- User-Config Save115
- Firmware Upgrade115
- Ping116
- Tracert116
- Loopback117
- Show System-Info117
- Show Ip Address118
- Show System-Time118
- Show System-Time Dst119
Chapter 20 Ethernet Configuration Commands120
- Interface Ethernet120
- Interface Range Ethernet120
- Description121
- Shutdown121
- Flow-Control122
- Negotiation122
- Storm-Control123
- Storm-Control Disable Bc-Rate124
- Storm-Control Disable MC-Rate124
- Storm-Control Disable Ul-Rate125
- Port Rate-Limit125
- Port Rate-Limit Disable Ingress126
- Port Rate-Limit Disable Egress126
- Show Interface Configuration126
- Show Interface Status127
- Show Interface Counters127
- Show Storm-Control Ethernet128
- Show Port Rate-Limit128
Chapter 21 Qos Commands130
- Qos130
- Qos Dot1P Config130
- Qos Dscp Enable131
- Qos Dscp Config132
- Qos Scheduler133
- Show Qos Port-Based134
- Show Qos Dot1P134
- Show Qos Dscp134
- Show Qos Scheduler135
Chapter 22 Port Mirror Commands136
- Mirror Add136
- Mirror Remove Group137
- Mirror Remove Mirrored137
- Show Mirror138
Chapter 23 Port Isolation Commands139
- Port Isolation139
- Show Port Isolation139
Chapter 24 Poe Commands141
- Power Inline Consumption (Global Configuration)141
- Power Inline Disconnect-Method141
- Power Inline Supply Status142
- Power Inline Priority142
- Power Inline Consumption (Interface Configuration)143
- Power Inline Time-Segment143
- Power Inline Profile144
- Power Profile144
- Power Time-Segment145
- Power Holiday146
- Show Power Inline147
- Show Power Inline Configuration147
- Show Power Inline Information148
- Show Power Time-Segment148
- Show Power Holiday148
- Show Power Profile149
Chapter 25 ACL Commands150
- Acl Time-Segment150
- Acl Edit Time-Segment151
- Acl Holiday152
- Acl Create152
- Acl Rule Mac-Acl153
- Acl Edit Rule Mac-Acl154
- Acl Rule Std-Acl155
- Acl Edit Rule Std-Acl156
- Acl Policy Policy-Add157
- Acl Policy Action-Add158
- Acl Edit Action159
- Acl Bind To-Port159
- Acl Bind To-Vlan160
- Show Acl Time-Segment160
- Show Acl Holiday161
- Show Acl Config161
- Show Acl Bind162
Chapter 26 MSTP Commands163
- Spanning-Tree Global163
- Spanning-Tree Common-Config164
- Spanning-Tree Region165
- Spanning-Tree Msti166
- Spanning-Tree Msti167
- Spanning-Tree Tc-Defend167
- Spanning-Tree Security168
- Spanning-Tree Mcheck169
- Show Spanning-Tree Global-Info169
- Show Spanning-Tree Global-Config170
- Show Spanning-Tree Port-Config170
- Show Spanning-Tree Region171
- Show Spanning-Tree Msti Config171
- Show Spanning-Tree Msti Port171
- Show Spanning-Tree Security Tc-Defend172
- Show Spanning-Tree Security Port-Defend172
Chapter 27 IGMP Commands174
- Igmp-Snooping Global174
- Igmp-Snooping Config174
- Igmp-Snooping Vlan-Config-Add175
- Igmp-Snooping Vlan-Config176
- Igmp-Snooping Multi-Vlan-Config177
- Igmp-Snooping Static-Entry-Add178
- Igmp-Snooping Filter-Add179
- Igmp-Snooping Filter-Config179
- Igmp-Snooping Filter180
- Show Igmp-Snooping Global-Config181
- Show Igmp-Snooping Port-Config181
- Show Igmp-Snooping Vlan-Config182
- Show Igmp-Snooping Multi-Vlan182
- Show Igmp-Snooping Multi-Ip-List182
- Show Igmp-Snooping Filter-Ip-Addr183
- Show Igmp-Snooping Port-Filter183
- Show Igmp-Snooping Packet-Stat184
- Show Igmp-Snooping Packet-Stat-Clear184
Chapter 28 SNMP Commands185
- Snmp Global185
- Snmp View-Add186
- Snmp Group-Add186
- Snmp User-Add188
- Snmp Community-Add189
- Snmp Notify-Add190
- Snmp-Rmon History Sample-Cfg191
- Snmp-Rmon History Owner192
- Snmp-Rmon History Enable192
- Snmp-Rmon Event User193
- Snmp-Rmon Event Description193
- Snmp-Rmon Event Type194
- Snmp-Rmon Event Owner195
- Snmp-Rmon Event Enable195
- Snmp-Rmon Alarm Config196
- Snmp-Rmon Alarm Owner197
- Snmp-Rmon Alarm Enable198
- Show Snmp Global-Config198
- Show Snmp View199
- Show Snmp Group199
- Show Snmp User199
- Show Snmp Community200
- Show Snmp Destination-Host200
- Show Snmp-Rmon History200
- Show Snmp-Rmon Event201
- Show Snmp-Rmon Alarm201
Chapter 29 LLDP Commands203
- Lldp Enable203
- Lldp Hold-Multiplier203
- Lldp Timer204
- Lldp Med-Fast-Count205
- Lldp Admin-Status205
- Lldp Snmp-Trap206
- Lldp Tlv-Select207
- Lldp Med-Status207
- Lldp Med-Tlv-Select208
- Lldp Med-Location208
- Show Lldp Global209
- Show Lldp Interface209
- Show Lldp Local-Information210
- Show Lldp Neighbor-Information210
- Show Lldp Statistics211
- Show Lldp Med Fast-Count211
- Show Lldp Med Interface212
- Show Lldp Med Local-Information212
- Show Lldp Med Neighbor-Information213
Chapter 30 Cluster Commands214
- Cluster Ndp214
- Cluster Ntdp215
- Cluster Explore216
- Cluster216
- Cluster Manage Role-Change217
- Show Cluster Ndp Global217
- Show Cluster Ndp Port-Status218
- Show Cluster Neighbour218
- Show Cluster Ntdp Global218
- Show Cluster Ntdp Port-Status219
- Show Cluster Ntdp Device219
- Show Cluster Manage Role220

TP-Link JetStream TL-SG3424P - Page 13

Table of Contents

Other manuals for TP-Link JetStream TL-SG3424P

Related product manuals