TP-Link T1700G-28TQ - Page 226

216
Choose the menu Network Security→802.1X→Port Config to load the following page.
Figure 13-22 Port Config
The following entries are displayed on this screen:

Port Config
UN IT:
Click unit number to configure the physical ports of this unit
member.
Select:
Select your desired port for configuration. It is multi-optional.
Port:
Displays the port number.
Status:
Select Enable/Disable the 802.1X authentication feature for the
port.
Guest VLAN:
Select Enable/Disable the Guest VLAN feature for the port.
Control Mode:
Specify the Control Mode for the port.
 Auto:
In this mode, the port will normally work only after passing
the 802.1X Authentication.
 Force-Authorized:
In this mode, the port can work normally
without passing the 802.1X Authentication.
 Force-Unauthorized:
In this mode, the port is forbidden working
for its fixed unauthorized status.
Control Type:
Specify the Control Type for the port.
 MAC Based:
Any client connected to the port should pass the
802.1X Authentication for access.
 Port Based:
All the clients connected to the port can access the
network on the condition that any one of the clients has passed
the 802.1X Authentication.
Authorized:
Displays the authentication status of the port.
LAG:
Displays the LAG to which the port belongs to.