Trace Engineering RC7 User Manual

ã 1999 Trace Engineering
RC7 & RC7GS Remote Controls
3.0 OPERATION
4. Low Battery Voltage
The “Lobat/Start Chrg” System Status message is displayed when the
battery voltage drops below a safe level. The red Error LED illuminates and the
Buzzer sounds. The inverter shuts off to prevent damage to the batteries.
Provide an ac supply (such as shore power or a generator) to the inverter/
charger to automatically start charging the batteries.
Figure 50
Error Display–Low Battery Voltage
26
System Status:
Lobat/Start Chrg
Inverter
Charge
Batt. Full
Error
822-4A-001
Error LED ON
Error Condition
Remedy
Buzzer Sounds
NOTE: Press any arrow push-button to cancel the buzzer.
3. High Battery Voltage
The “Hibat/Stop Chrg” System Status message is displayed when the
battery voltage is too high. Switch off any other charging sources to allow the
voltage level to drop. The inverter automatically resets and resumes operation
when the battery reaches a safe voltage level. This condition usually occurs only
when an additional charging source is used to charge the battery bank.
Figure 49
Error Display–High Battery Voltage
System Status:
Hibat/Stop Chrg
Inverter
Charge
Batt. Full
Error
822-4A-001
Error LED ON
Error Condition
Remedy
Buzzer Sounds
NOTE: Press any arrow push-button to cancel the buzzer.

Trace Engineering RC7 Specifications

General

Brand	Trace Engineering
Model	RC7
Category	Remote Control
Language	English