Trane AdaptiView - Chiller Settings

CTV-SVU02A-EN 37
Equipment Settings
Chiller Settings
Ta b l e 6 lists the settings that are available as buttons on the Chiller Settings menu screen, along
with their corresponding setting options. The chiller configuration determines which of the settings
appear.
Table 6. Chiller Settings menu screen: Buttons and available setting options
Buttons Available setting options
Setpoint Source
•BAS/Ext/FP
•Ext/FP
• Front Panel
Front Panel Control Type
• Chilled Water
•Hot Water
Front Panel Chilled Water Setpoint
(a)
Valid numerical range appears on screen.
Front Panel Hot Water Setpoint
(a)
Valid numerical range appears on screen.
Front Panel Ice Building Command
•Auto
•On
Front Panel Ice Termination Setpoint
(a)
Valid numerical range appears on screen.
Ice to Normal Cooling Timer Setpoint Valid numerical range appears on screen.
Front Panel Current Limit Setpoint
(a)
Valid numerical range appears on screen.
Front Panel Free Cooling Command
•Auto
•On
Front Panel Base Loading Setpoint
(a)
Valid numerical range appears on screen.
Front Panel Base Load Command
•Auto
•On
Differential to Start Valid numerical range appears on screen.
Differential to Stop Valid numerical range appears on screen.
Evaporator Leaving Water Temperature Cutout Valid numerical range appears on screen.
Low Refrigerant Temperature Cutout Valid numerical range appears on screen.
Condenser Water Pump Off Delay Valid numerical range appears on screen.
Evaporator Water Pump Off Delay Valid numerical range appears on screen.
Evaporator Low Water Flow Warning Setpoint Valid numerical range appears on screen.
Maximum Capacity Limit Valid numerical range appears on screen.
Minimum Capacity Limit Valid numerical range appears on screen.
Check Oil Filter Setpoint Valid numerical range appears on screen.
Capacity Control Softload Time Valid numerical range appears on screen.
Current Limit Control Softload Time Valid numerical range appears on screen.
Current Limit Control Softload Start Point Valid numerical range appears on screen.
Local Atmospheric Pressure Valid numerical range appears on screen.
Power-Up Start Delay Time Valid numerical range appears on screen.
Starter Power Demand Time Period Valid numerical range appears on screen.
(a) This is an arbitrated setpoint. For an complete explanation of arbitrated setpoints, see “Setpoint Sources,” p. 38.