CTV-SVU02A-EN 43
Equipment Settings
To change a manual control setting, follow this procedure:
1. In the Equipment Settings column on the Settings screen, touch Manual Control Settings. The
Manual Control Settings screen appears (Figure 24).
2. Touch the button that shows the manual control setting you want to change. A screen for
changing the manual control setting appears (Figure 25, p. 44).
3. Touch the button that represents the setting you want. The button becomes shaded and Apply
and Save buttons appear at the bottom of the screen.
Note: The Compressor Control Signal screen provides up/down arrow keys and numerical
fields for selecting a value.
4. To save your change, do one of the following:
• To u ch Apply. The change is communicated to the Tracer UC800 controller. You can observe
the status points in the lower half of the screen change in response to the setting change you
just made. Also, a Manual Override button appears in the upper left corner of the screen (see
Figure 25, p. 44).
• Touch Save. The change is communicated to the Tracer UC800 controller. The screen you
were previously viewing appears.
Figure 24. Manual Control Settings screen
To Next Page
Loading...
