Chapter 7 Commands
TransCore Proprietary
7–99
For example, 10 = 16 seconds and FF = 255 seconds. The factory default is 4601 (1 second).
Uppercase or lowercase characters are allowed for NN; for example, hex digits A through F or athroughf
Reader response:
Done
For commands 480 through 489, see “570 Display Tag Protocols” on page 7–112.
480 Disable ATA
Command #480 disables the reader from reading ATA protocol tags.
481 Enable ATA
Command #481 enables the reader to read ATA protocol data from tags if the reader is programmed to
read this tag protocol.
482 Disable eGo
Command #482 disables the reader from reading eGo protocol data from tags.
483 Enable eGo
Command #483 enables the reader to read factory-programmed eGo data from tags if the reader is
programmed to read this tag protocol.
484 Disable SeGo
Command #484 disables the reader from reading SeGo protocol data from tags.
485 Enable SeGo
Command #485 enables the reader to read SeGo protocol data from tags if the reader is programmed to
read this tag protocol.
486 Disable IAG
Command #486 disables the reader from reading IAG protocol data from tags.
487 Enable IAG
“00 Switch to Data Mode (Factory Default)” on page 7–75
Command #487 enables the reader to read IAG protocol data from tags if the reader is programmed to
read this tag protocol. This command should be used in conjunction with “648NN Set Synchronization
Output Delay Time” on page 7–123 and “648NN Set Synchronization Output Delay Time” on page 7–123.
488 Disable eATA
Command #488 disables the reader from reading factory-programmed eATA data from tags.
To Next Page
Loading...
