Table 43 Encompass 4 Reader Default Configuration Settings
Parameter Setting Command
Communications protocol
Basic 610
Error correcting protocol (ECP) timeout
12.7 sec 612FE
Flow control
Software (XON/XOFF) 6141
Echo mode
Enabled 6171
Sense output control
Predefined 621
RF-by-input control
Enabled 641
ATA operating range
Maximum 6431F
RF attenuation
Full power 64400
eGo and eGo Plus Tag operating range
Maximum 6451F
IAG attenuation 4 dBm 64604
Set Frequency
a
915MHz 6470DC
Sense output pulse duration 228 ms 67C
Presence without tag reports
Disabled 6900
RF-o control
Timeout or no presence 6922
RF timeout
Never true 693F
Input inversion
Disabled 6940
Serial number
NNNNNN 695
Store hardware configuration
Hardware configuration not
known
696
Input status change reports
Disabled 820
Automatic periodic RF status report
Disabled
830
a Local laws apply. The authorized frequency band for the TransCore Encompass 4 Reader in the United States is
911.75 MHz to 919.75 MHz. Contact TransCore if your application requires a frequency outside of this range.
Configuring Parameters with Terminal Emulation
Software
To configure the Encompass 4 Reader using a PC and terminal emulation software to manually enter
Encompass 4 Reader host commands, follow the instructions in the section “Connecting the Encompass
4 Reader to the PC” on page 4-55. Then, enter the appropriate configuration commands through the
terminal emulation software on your PC.
See “Chapter 7 Commands” on page 7–86 for a detailed description of all available configuration
commands.
Chapter 8 Configuring the Encompass 4 Reader
TransCore Proprietary
8–135
To Next Page
Loading...
