Double-sided Tape
You need the following materials to install the LPT with double-sided tape:
• Rubbing alcohol, 50/50 isopropyl alcohol and water, or solvent/cleaner for metal
• Sponge and dry cloth
• LPT with the double-sided adhesive tape attached
1. Clean and degrease the tag installation area of the vehicle bumper with solvent/cleaner.
2. Dry the area thoroughly using a clean, dry cloth.
3. Remove the backing from the double-sided tape on the back of the tag.
4. Position the tag over the installation area, making sure that the tag and the reader orientation are the
same (horizontal or vertical).
5. Press the tag firmly against the bumper.
Blind Rivets
1. Position the tag on the bumper in the installation area and mark the hole positions of the tag’s
installation tabs on the bumper.
2. Follow the rivet manufacturer’s instructions to drill holes in the bumper for rivets.
3. If the rivet head is smaller than the tag installation holes and can be pulled through the holes, use a
small washer to secure the rivet through the tag.
Note: To remove an exterior tag installed with rivets, follow the rivet manufacturer’s instructions to
remove the rivets.
eGo Plus Mini External Tag
The eGo Plus Mini External Tag can be installed on any flat or slightly curved glass, plastic, or metal
surface. The tag is attached with two strips of durable non-removable adhesive.
1. The outward-facing side of the tag should be pointed toward the front of the vehicle. Position the tag
so that no part of the vehicle hangs over the tag. The tag should have a minimum field-of-view of 90
degrees. Refer to Figure 22 for correct tag placement.
Encompass 4 Reader System Guide
TransCore Proprietary.
3–30
To Next Page
Loading...
