Transition Networks SGPAT1013-105 - 6-Position DIP Switch

Transition Networks SGPAT10xx-x05 PoE+ Converter User Guide
33719 Rev. C https://www.transition.com Page 11 of 49
6-Position DIP Switch
A 6-Position DIP Switch is provided for basic SGPAT configuration.
The DIP switch default is all in the UP position. The DIP switch default setting is valid
until CLI DIP Switch Override is Enabled (which is disabled by default).
See CLI DIP Switch Override (c Command) on page 28 for more information.
The DIP Switch settings are shown and described below.
Switch 1 Port 3: Up=100/1000 or Down=SGMII
Applies to these versions:
SGPAT1040-105
SGPAT1040-205
SGPAT1040-305
Switch 2 Port 4: Up=100/1000 or Down=SGMII
Applies to these versions:
SGPAT1040-205
SGPAT1040-305
Switch 3 ALPT: Up=Disabled or Down=Enabled
Applies to these versions:
SGPAT1013-105
SGPAT1039-105
SGPAT1040-105
SGPAT1040-205 with DIP Switch 4 down (Redundant mode enabled)
SGPAT1040-305 with DIP Switch 6 down (2-Converter mode enabled)
Switch 4 Redundant mode: Up-Normal or Down=Redundant
Applies to these versions:
SGPAT1040-205
SGPAT1040-305 with DIP Switch 6 Up (2-Converter mode disabled)
Switch 5 Revertive mode: Up=Revertive or Down=Non-revertive
Applies to these versions:
SGPAT1040-205
SGPAT1040-305 with DIP Switch 6 Up (2-Converter mode disabled)
Switch 6 2-Converter mode: Up=Disabled or Down=Enabled
Applies to this version:
SGPAT1040-305