Transition Networks SGPAT1013-105 - Auto Negotiation (AN) Enable for TP Ports or an Disable with Port Forced Mode (N Command)

Transition Networks SGPAT10xx-x05 PoE+ Converter User Guide
33719 Rev. C https://www.transition.com Page 36 of 49
Auto Negotiation (AN) enable for TP ports or AN disable with port forced mode (n Command)
This command lets you view and configure SGPAT Auto Negotiation, Speed, and Duplex settings.
n – Auto Negotiation (AN) {PORT 1-2} {Forced: 0 | Enable: 1} {Forced Mode 1-4}
Type n and press the Enter key to display the current stored Auto Negotiation setting.
Type n11 and press the Enter key to enable Auto Negotiation on TP port 1.
Type n21 and press the Enter key to enable Auto Negotiation on TP port 2 (only when TP port 2 is present).
Type n101 and press the Enter key to disable Auto Negotiation and force TP port 1 to 100Base full duplex mode.
Type n102 and press the Enter key to disable Auto Negotiation and force TP port 1 to 100Base half-duplex mode.
Type n103 and press the Enter key to disable auto negotiation and force TP port 1 to 10Base full duplex mode.
Type n104 and press the Enter key to disable Auto Negotiation and force TP port 1 to 10Base half-duplex mode.
Type n201 and press the Enter key to disable Auto Negotiation and force TP port 2 to 100Base full duplex mode
(only when TP port 2 is present).
Type n202 and press the Enter key to disable Auto Negotiation and force TP port 2 to 100Base half-duplex mode
(only when TP port 2 is present).
Type n203 and press the Enter key to disable Auto Negotiation and force TP port 2 to 10Base full duplex mode
(only when TP port 2 is present).
Type n204 and press the Enter key to disable Auto Negotiation and force TP port 2 to 10Base half-duplex mode
(only when TP port 2 is present).
Operation is the same on all models.
n Command Example:
%n – Auto Negotiation(AN) {PORT 1-2)} {Forced:0 | Enable:1}{Forced Mode 1-4}:
1- 100FULL, 2-100HALF, 3-10FULL, 4-10HALF
example: n101 – AN Port 1 Forced to Speed:100M Duplex:Full,
n21 – AN Port2 Enable
%n
Auto Negotiation: Port 1 Enable
Auto Negotiation: Port 2 Enable
%n – Auto Negotiation(AN) {PORT 1-2)} {Forced:0 | Enable:1}{Forced Mode 1-4}:
1- 100FULL, 2-100HALF, 3-10FULL, 4-10HALF
example: n101 – AN Port 1 Forced to Speed:100M Duplex:Full,
n21 – AN Port2 Enable
%