Transition Networks SGPAT1013-105 - PSE Port Legacy Detect Mode (L Command)

Transition Networks SGPAT10xx-x05 PoE+ Converter User Guide
33719 Rev. C https://www.transition.com Page 34 of 49
PSE Port Legacy Detect Mode (l Command)
This command displays the current stored PSE Port Legacy Detect Mode (enabled or disabled).
l – PSE Legacy Mode {Port 1-2} {Disable:0 | Enable:1 }
Type l and press the Enter key to display the current stored PSE Port Legacy Detect Mode.
Type l10 and press the Enter key to disable legacy detection mode and use standard IEEE detection on Port 1.
Type l11 and press the Enter key to enable legacy detection mode only on Port 1.
Type l20 and press the Enter key to disable legacy detection mode and use standard IEEE detection on Port 2.
Type l21 and press the Enter key to enable legacy detection mode only on Port 2.
Model Descriptions
SGPAT1013-105, SGPAT1039-105, SGPAT1040-105, SGPAT1040-205: Copper Port 1 of these models will enable
and disable the support for legacy type PD devices.
SGPAT1040-305 : Both Copper Ports 1and 2 of this model will enable and disable the support for legacy type PD
devices.
l Command Example:
%l ?
PSE Legacy: Port 1 Disabled(IEEE 802.3 at/af Devices Detected)
PSE Legacy: Port 2 Disabled(IEEE 802.3 at/af Devices Detected)
%l11
PSE Legacy Mode Stored
%l?
PSE Legacy: Port 1 Enable(Only Legacy Devices Detected)
PSE Legacy: Port 2 Disabled(IEEE 802.3 at/af Devices Detected)
%