Transition Networks SGPAT1013-105 - Port Isolation Mode (I Command)

Transition Networks SGPAT10xx-x05 PoE+ Converter User Guide
33719 Rev. C https://www.transition.com Page 33 of 49
Port Isolation Mode (I Command)
This command lets you view and configure the current Isolation Port mode.
I – Isolated Port Mode {Disable: 0 | Enable: 1}
Type I and press the Enter key to display the current stored Port Isolation mode.
Type i0 and press the Enter key to disable port isolation.
Type i1 and press the Enter key to enable port isolation.
Model Descriptions
SGPAT1040-205: Only when this converter model is in Normal Mode, the two SFP ports will be isolated and will
only be able to communicate to the TP port. The TP port will be able to communicate to both SFP ports.
SGPAT1040-305: Only when this converter model is in Redundancy mode, the two TP ports will only be able to
communicate to the active SFP port. The active SFP port will be able to communicate to both TP ports.
I Command Example:
I – Isolated Port Mode {Disable:0 | Enable:1}
example: i0 – Isolation Disable, i1 – Isolation Enable
%i1
%i
Port Isolation: Unavailable
%i
Port Isolation: Unavailable