Transition Networks SGPAT1013-105 - Complete Configuration Status Report (M Command)

Transition Networks SGPAT10xx-x05 PoE+ Converter User Guide
33719 Rev. C https://www.transition.com Page 35 of 49
Complete Configuration Status Report (m Command)
This command displays the current SGPAT configuration settings.
m – Complete Status Report
Type m and press the Enter key to display the current converter configuration settings. (This works the same as
pressing a, c, d, e, f, I, l, n, p, r, s).
Operation is the same on all models.
m Command Example:
%m?
ALPT: Unavailable
DIP Switch Override: Enable
Dual Converter Mode: Disable
Flow Control Status
Port 1:Disabled
Port 2:Disabled
Port 3:Disabled
Port 4:Disabled
Port Isolation: Unavailable
PSE Legacy: Port 1 Disabled(IEEE 802.3 at/af Devices Detected)
PSE Legacy: Port 2 Disabled(IEEE 802.3 at/af Devices Detected)
Auto Negotiation: Port 1 Enable
Auto Negotiation: Port 2 Enable
Auto Power PD Reset: Unavailable
Redundant Mode: Disabled
SFP Port 3:100/1000
SFP Port 4:100/1000
%