Transition Networks SGPAT10xx-x05 PoE+ Converter User Guide
33719 Rev. C https://www.transition.com Page 17 of 49
Powering
You must either a) use the provided external AC-DC adapter or b) ensure that the alternate power source meets
the IEEE 802.3at isolation requirements. Perform all configuration and cabling before powering the SGPAT.
Power Connection
Use the supplied AC power adapter to power the SGPAT standalone converter. To connect power to the SGPAT:
1. Connect the barrel connector on the power adapter cord to the power connector on the media converter
56VDC INPUT as shown below.
2. Plug the power adapter AC plug into AC power.
3. Verify that the SGPAT has powered UP - the power LED on the front panel is lit.
To Next Page
Loading...
