Transition Networks SGPAT1013-105 - Page 26

Transition Networks SGPAT10xx-x05 PoE+ Converter User Guide
33719 Rev. C https://www.transition.com Page 26 of 49
s – SFP Port Mode {Port} {SGMII: s0 | 100Base-FX/1000BaseX: s1} (see page 40)
t – Show Internal Temperature of Converter and SFP (see page 42)
x – Reset to Factory Defaults (see page 42)
To display all of the available SGPAT commands, press the Enter key twice.
Transition Networks SGPAT Commands:
a – Active Link Pass Through {Disable:0 | Enable:1}
example: a0 – ALPT Disable, a1 – ALPT Enable
c – CLI Dip Switch Override {Disable:0 | Enable:1}
example: c0 – Dip Switch Control, c1 – CLI Control
d – Dual Converter Mode {Disable:0 | Enable:1}
example: d0 – DC Disable, d1 – DC Enable
e – Energy Efficient Ethernet Adv. Ports {Port 1-2} {Disable:0 | Enable:1 }
example: e10 – EEE Disable Port 1, e11 – EEE Enable Port 1
f – Flow Control {PORT 1-4} {Disable:0 | Enable:1}
example: f10 – FC Port 1 Disable, f21 – FC Port2 Enable
g – Get PSE Status Report
I – Isolated Port Mode {Disable:0 | Enable:1}
example: i0 – Isolation Disable, i1 – Isolation Enable
l – PSE Legacy Mode {Port 1-2} {Disable:0 | Enable:1 }
example: l10-PSE Legacy Disable Port 1, l11-PSE Legacy Enable Port 1
m – Complete Status Report
n – Auto Negotiation(AN) {PORT 1-2)} {Forced:0 | Enable:1}{Forced Mode 1-4}:
1- 100FULL, 2-100HALF, 3-10FULL, 4-10HALF
example: n101 – AN Port 1 Forced to Speed:100M Duplex:Full,
n21 – AN Port2 Enable
p – Auto Power PD RESET {Port 1-2} {Disable:0 | Enable:1}
example: p10 – Auto Power PD RESET Disable Port 1,
p11 – Auto Power PD RESET Enable Port 1
r – Redundancy Mode {Disable:0 | Enable Revert:1 | Enable Non-Revert:2}
example: r0 – Disable, r1 – Enable Revert, r2 – Enable Non-Revert
s – SFP Port Mode{Port#:3 or 4}{SGMII:0 | 100/1000BaseX:1}
format : s<port #><mode>
example: s31, port# <3> mode 100/1000 <1>
t – Temperature of Switch
x – Factory Default
%
The SGPAT CLI commands are described in the following sections.