10
10.2016
WTAL - TNX65/42
Maintenance Instructions
Visual inspection of all fluid lines and wiring
It is essential to examine all fluid lines and wiring at regular intervals, in
accordance with the service time and use of the machine, as well as the
different ambient conditions.
In this way, potential faults or problems can be identified and remedied at an
early stage.
Risk of injury due to escaping fluid!
Fluids may escape from damaged fluid lines at high pressure.
Personal protective equipment must therefore always be worn
during visual inspections.
If such visual inspection reveals defects in fluid lines or wiring, the machine
must be switched off and the defective lines or leads replaced without delay.
Fluid lines which have been replaced must be tightened down with
the torque specified by the manufacturer.
To Next Page
Loading...