52
10.2016
WTAL - TNX65/42
Maintenance work every 4 000 hours of operation
Control cabinet
Danger due to electric power
Work on motors or other electrical assemblies may only be carried
out by specially trained and instructed personnel!
Electrical components may still be energized even when the
machine has been switched off. These components are marked
accordingly and must not be touched before expiry of the specified
discharge time.
Clean the interior of the control cabinet
• Set main switch to position "0" and secure it so it cannot be reactivated.
• Clean the interior of the control cabinet.
Check and retighten connections
• Check all connections in the control cabinet.
• Retighten any loose connections.
• Remove the covers from the busbars on the amplifiers and retighten all
connections. Then refit the covers.
E05
To Next Page
Loading...