39
10.2016
WTAL - TNX65/42
Maintenance work every 2 000 hours of operation
D
Maintenance work every 2 000 hours of operation
No. Where What Comments
01 see A, B, C • Carry out all the maintenance work
listed under A, B and C
02 Hydraulic system • Replace filter cartridge in the pressure filter
03 Axes • Check grid intervals and reference points
04 Hollow clamping
cylinder, main
spindle / opposed
spindle if applicable
• Clean lubricoolant collecting pan
05 Ball screw
transmission, axes
• Determine the reversing backlash Switch on the
machine
06 Cover in the
working area
• Check wipers on cover panels of main and
opposed spindles, replace if necessary
Switch on the
machine
To Next Page
Loading...