Traub TX8i-s - F04; O-Rings; Check and if Necessary Replace O-Rings

57
10.2016
WTAL - TNX65/42
Maintenance work every 8 000 hours of operation
O-rings
Check and if necessary replace O-rings
This maintenance work can only be carried out when the machine is
switched on.
Installed location Article No.
Chuck element 479105.2201
Lubricoolant bush 479103.0071
Workholding fixture hollow clamping
cylinder
319 378
Rinsing device hollow clamping
cylinder
316 463
323 480
Workholding fixture solid clamping cylinder 316 463
Rinsing device solid clamping cylinder 316 684
311 769
321 138
Ejector and rinsing device 479103.0141
479103.0202
479103.0232
322 575
321 056
323 480
Discharge through the opposed spindle 479103.0642
300 843
Threaded bush/attachments for chuck 318 494
319 307
319 378
328 115
300 843
319 817
F04