-20-
Edge Moulding
and Grooving
Cutter Rotation
Feed Direction
Feed Direction
n Always work with constant, me-
dium rate. Feeding too slow will
results in burn marks and exces-
sive heat build up of the cutter.
n Good results will be obtained by
removing small amounts of mate-
rial in several passes.
n Always feed work in the opposite
direction to the direction of rota-
tion of the router cutter.
n Isolate from power source.
n Fit cutter.
n Set back fence position.
n Set top and side pressures.
n Fit guard.
n Check all knobs are tight.
n Plug into power supply.
n Switch on.
n Feed right to left.
n Switch off.
✓
✗
To Next Page
Loading...
