-1-
ROUTER TABLE
WRT
TECHNICAL DATA
UK & Eire 240V tools 13 Amperes, in plug
Europe 230V tools 10 Amperes, in mains
Fuses
INTENDED USE
The unit is intended for stationary operation of
portable routers for the cutting of wood or wood
based material when suitable cutter is fitted.
It is not intended for continuous production or
production line use.
This unit must not be put into service until it
has been established that the power tool to
be connected to this unit is compliance with
2006/42/EC (identified by the CE marking on the
power tool).
This router table is a professional product.
DO NOT use under wet conditions or in presence of
flammable liquids or gases.
DO NOT let children come into contact with
this appliance. Supervision is required when
inexperienced operators use this appliance.
This product is not intended for use by persons
(including children) suffering from diminished
physical, sensory or mental abilities ; lack of
experience, knowledge or skills unless they are
supervised by a person responsible for their safety.
Children should never be left alone with this product.
Voltage UK & Eire V
AC
240
Europe V
AC
230
On/off switch No-volt
release
Dimensions Width x mm 804 x
depth 604
Table height mm 840
Cutter diameter max. mm 86
Cutter height max. mm 55
Loss of cutting mm 6.35
depth due to table
thickness
Workpiece height max. mm 60
Workpiece length max.* mm 800
Weight kg 27.5
*Unless a workpiece support is used.
To Next Page
Loading...
