TREND WRT - Stopped Moulding Procedure

-21-
WRT
n Isolate from power supply.
n Fit cutter.
n Set back fence position.
Fit some stops to back fence
using cramps or use
accessory limit stop
Ref.WRT/2 (1 off).
n Fit guard.
n Check all knobs are tight
n Plug into power supply.
n Switch on.
n Drop material against infeed
stop A and pivot into cutter.
n Feed right to left, until reach-
ing outfeed limit stop B.
n Pivot at outfeed stop.
n Switch off.
Stopped Moulding
B A
B A
AB