TRENDnet AC750 - Inbound Filter Settings

© Copyright 2013 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-810DR
22
• Rule Name: Enter the name of the rule you would like to assign.
• LAN IP Address Range: Enter the IP address or IP address range to apply the
protocol (e.g. 192.168.10.20-192.168.10.20 or 192.168.10.20-192.168.10.30).
Note: The filter will not be applied to IP addresses outside of the range specified.
• Schedule: Select the defined schedule you would like to have the rule to be applied
(see “Create Schedule
” section on page 34).
Website Filter
Advanced > Security > Access Control
You may want to allow or block computers or devices on your network access to specific
websites (e.g. www.trendnet.com
, etc.), also called domains or URLs (Uniform Resource
Locators). You may also enter a keyword (e.g. instead of complete URL to generally
allow or block computers or devices access to websites that may contain the keyword in
the URL or on the web page.
1. Log into your router management page (see “Access your router management page”
on page 15).
2. Click on the Advanced tab.
3. Click on the Security section and click on Access Control.
4. Select to ALLOW or DENY websites listed.
5. Review the website rule settings and click Apply to save changes.
\
• Rule Enable: Check this potion to enable URL rule
• Rule Name: Enter the name of the URL rule
• URL: Enter the URL to apply to the rule
• Schedule: Click the drop-down list to select the pre-defined schedule to apply. The
filter will only be active during the time period defined in the pre-defined schedule.
(See “Create Schedule
” section on page 34).
Inbound Filter
Advanced > Security > Inbound Filter
1. Log into your router management page (see “Access your router management page
”
on page 15).
2. Click on the Advanced tab.
3. Click on the Security section and click on Access Control.
4. Review the inbound filter settings and click Apply to save changes.