TRENDnet AC750 - IPv6 Internet Connection Settings

© Copyright 2013 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-810DR
28
3. Click on the Setup section and click on Routing.
4. Review the LAN/WAN Static Routes section. Click Apply to save settings.
• Enable RIP: Select Enable on the pull down to enable RIP
• RIP mode: Select the RIP version to use.
IPv6 Internet Connection Settings
Advanced > Setup > IPv6 Setting
IPv6 (Internet Protocol Version 6) is a new protocol that significantly increases the
number of available Internet public IP addresses due to the 128-bit IP address structure
versus IPv4 32-bit address structure. In addition, there are several integrated
enhancements compared to the most commonly used and well known IPv4 (Internet
Protocol Version 4) such as:
• Integrated IPsec – Better Security
• Integrated Quality of Service (QoS) – Lower latency for real-time applications
• Higher Efficiency of Routing – Less transmission overhead and smaller routing tables
• Easier configuration of addressing
Note: In order to use IPv6 Internet connection settings, it is required that your ISP
provide you with the IPv6 service. Please contact your ISP for availability and more
information about the IPv6 service.
1. Log into your router management page (see “Access your router management page
”
on page 15).
2. Click on the Advanced tab.
3. Click on the Setup section and click on IPv6 Setting.
4. Review the IPv6 Internet Connection settings and enter information settings specified
by your ISP.
• IPv6 Connection Type: Select your IPv6 connection.
o 6to4: 6to4 is provided as a transitional mechanism for migrating from IPv4 to
IPv6. It allows IPv6 packets to be transmitted over an IPv4 network through the
automatic tunneling technology and routes traffic between 6to4 and IPv6
networks.