© Copyright 2015 TRENDnet. All Rights Reserved.
15
TRENDnet User’s Guide
TEW-814DAP
4. Review the settings, click Apply when finished.
• Enable SSID: Select to enable the selected wireless network/band.
• Wireless Network Name: Enter the wireless name (SSID) for your wireless network.
This acronym stands for Service Set Identifier and is the name of your wireless
network. It differentiates your wireless network from others around you
• Security Mode: Select the security type you would like to apply.
Note: To verify that the multiple SSIDs are active, using a wireless device, scan for
available wireless networks and check if the wireless device is able to discover the SSIDs.
To check connectivity, using a wireless device, connect to these SSIDs using the wireless
security types you have configured.
Advanced wireless settings
Wireless > Advanced
These settings are advanced options that can be configured to change advanced
wireless broadcast specifications. It is recommended that these settings remain set to
their default values unless you are knowledgeable about the effects of changing these
values. Changing these settings incorrectly can degrade performance.
• Transmit Power: Beacon Interval: A Select the percentage level of wireless transmit
power you would like to have the access point operate in.
Default Value: 100%
• WMM Enable: Select this option to enable WMM feature.
• Short GI: Select this option to enable Short guard interval feature.
• IGMP Snooping: Select this option to enable IGMP snooping feature.
• WLAN Partition: Select this option to disable the communication between
connected clients.
• HT20/40 Coexistence: Select enable to allow the access point to support both
20MHz and 40MHz.
To Next Page
Loading...
Need help?
General
