© Copyright 2015 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-814DAP
41
• Connected Time: Displays the duration time of your wireless client
• MAC Address: Displays the current MAC address of your wireless client.
.
Check the access point system information
Status > Device Info
You may want to check the system information of your access point such as IP address
settings, access point mode, wireless and wired network settings, access point wireless
MAC addresses, and firmware version.
1. Log into your access point management page (see “
Access your access point
management page” on page 8).
2. Click on Status and click on Device Info.
Device Info
• Firmware Version: The current firmware version your access point is running.
• System Up Time: The duration your access point has been running continuously
without a restart/power cycle (hard or soft reboot) or reset.
LAN Information
• Device Mode: Current operating mode access point is set.
• MAC Address: Displays the current Ethernet wired interface MAC address.
• Connection: LAN IP set to the access point
• IP Address: The current IP address settings assigned to your access point.
• Subnet Mask: The current subnet mask assigned to your access point.
• Default Gateway: The current gateway assigned to your access point.
2.4GHz Wireless
• MAC Address: The MAC address of your access point’s 5GHz wireless LAN or
interface configuration.
• SSID: Displays the SSID applied to the access point.
• Security Mode: Displays the wireless security type applied to your wireless
network.
• Channel Width: Current operating channel width set on the access point.
• Channel: Displays the current 5GHz wireless channel your access point is operating.
To Next Page
Loading...
Need help?
General
