© Copyright 2015 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-814DAP
37
Access Point Maintenance & Monitoring
Reset your Access Point to factory defaults
Tools > Settings Management
You may want to reset your access point to factory defaults if you are encountering
difficulties with your access point and have attempted all other troubleshooting. Before
you reset your access point to defaults, if possible, you should backup your access point
configuration first, see “
Backup and restore your access point configuration settings” on
page 35.
There are two methods that can be used to reset your access point to factory defaults.
• Reset Button – Located on the rear panel of your access point, see “
Product
Hardware Features” on page 2. Use this method if you are encountering
difficulties with accessing your access point management page.
OR
• Access Point Management Page
1. Log into your access point management page (see “
Access your access point
management page” on page 8).
2. Click on Tools and click on Settings Management.
3. Under Restore Factory Default Settings section, click Restore Default. When
prompted to confirm this action, click OK.
Access Point Default Settings
Administrator User Name admin
Administrator Password admin
Access Point Default URL http://tew-814dap/
Access Point IP Address 192.168.10.100
Access Point Subnet Mask 255.255.255.0
Mode Access Point
Wireless Enabled
Wireless Network Name/Encryption Please refer to sticker or
device label
Wireless Multiple SSID Disabled
Backup and restore your access point configuration settings
Tools > Settings Management
You may have added many customized settings to your access point and in the case that
you need to reset your access point to default, all your customized settings would be
lost and would require you to manually reconfigure all of your access point settings
instead of simply restoring from a backed up access point configuration file.
To backup your access point configuration:
1. Log into your access point management page (see “
Access your access point
management page” on page 8).
2. Click on Tools and click on Settings Management.
3. Next to Save Settings section, click Save.
To Next Page
Loading...
Need help?
General
