© Copyright 2015 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-814DAP
34
2. Click on Main, and click on Password.
3. Under the Device Name Settings section, in the Device Name field, enter the new
device name to display on your network to identify the access point. Click Save
Settings to apply changes.
Note: The access point’s device name is used to access the device using the URL
feature. If changed the device name you will need to access your access point
management page using your new access point IP address. (e.g. Instead of using
the default login URL
http://tew-814DAP
IPv6 Connection Settings
Main > IPv6
IPv6 (Internet Protocol Version 6) is a new protocol that significantly increases the
number of available Internet public IP addresses due to the 128-bit IP address structure
versus IPv4 32-bit address structure. In addition, there are several integrated
enhancements compared to the most commonly used and well known IPv4 (Internet
Protocol Version 4) such as:
• Integrated IPsec – Better Security
• Integrated Quality of Service (QoS) – Lower latency for real-time applications
• Higher Efficiency of Routing – Less transmission overhead and smaller routing tables
• Easier configuration of addressing
1. Log into your access point management page (see “
Access your access point
management page” on page 8).
2. Click on Main, and click on IPv6.
3. Select the IPv6 connection type to assign IPv6 addressing to the access point.
• Link-Local Only
• Auto-configuration (SLAAC/DHCPv6)
• Static IPv6
• LAN IPv6 Link-Local Address: Current IPv6 address applied to your access point.
Change your access point IP address
Main > Network Settings
Typically, the access point IP address settings only needs to be changed when
connecting the access point to your network and configuring to the device to be in the
same IP network as your existing network.
Default Access Point IP Address Settings: 192.168.10.100 / 255.255.255.0
1. Log into your access point management page (see “
Access your access point
management page” on page 8).
2. Click on Main, and click on Network Settings.
3. Under Connection Type, click the drop-down list to select the access point IP address
settings.
To Next Page
Loading...
Need help?
General
