© Copyright 2015 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-814DAP
32
change it to
Wait for the device to apply the settings.
7. To verify the access point has setting of the repeated signal and click Save to
continue. Wait for the settings to apply, it may take up to 1 minute for your device to
verify and display the connection status.
Advanced Access Point Setup
MAC Address Filters
Access > MAC Filters
Every network device has a unique, 12-digit MAC (Media Access Control) address. Using
MAC filters, you can allow or deny specific computers and other devices from using this
access point’s wireless network. You can enter up to 24 MAC address entries.
1. Log into your access point management page (see “
Access your access point
management page” on page 8).
2. Click on Access, click on MAC Filters.
3. Review the MAC Filter options, click Save Settings to save settings.
Click the Configuring MAC Filtering below drop-down list to choose the MAC filter
function.
• Turn MAC Filtering OFF: disables the MAC address filter.
• Turn MAC Filtering ON and ALLOW computers listed to access the network Only
Allow computers/devices with MAC addresses listed to access the access point
management page and the Internet. Deny all others. Turn MAC Filtering ON and
DENY computers listed to access the network
Only Deny computers/devices with MAC addresses listed to access to the access point
management page and the Internet. Allow all others.
Note: MAC filter can be configured to allow access to the listed MAC address and deny
all others unlisted or vice versa. The recommended function is to choose to only allow
access to the MAC addresses listed and deny all others unlisted because it is easier to
To Next Page
Loading...
Need help?
General
