© Copyright 2015 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-814DAP
33
determine the MAC addresses of devices in your network then to determine which MAC
addresses you do not want to allow access.
Before saving settings, add the MAC addresses to the MAC Table and configure the
options first.
• MAC Address: Enter the MAC address of the devices you would like to filter. (e.g.
00:11:22:AA:BB:CC)
Note: If you uncertain of the device MAC address, please refer to your computer or
device documentation to find the MAC address.
• Schedule: Select from the pull down menu a schedule of when to apply the MAC
filter rule, or click Add New to add a new schedule.
User Limit
Access > User limit
The access point allows you to configure the amount of users allowed to connect to
your wireless network.
1. Log into your access point management page (see “
Access your access point
management page” on page 8).
2. Click on Access, click on User Limit.
3. Review the User Limit options, click Save Settings to save settings.
• Enable User Limit: Select this option to turn on user limit feature
• User Limit: Enter the amount of users you would like to allow on your wireless
network.
Change your access point login password
Main > Password
1. Log into your access point management page (see “
Access your access point
management page” on page 8).
2. Click on Main, and click on Password.
3. Under the Password section, in the Password field, enter the new password. Click
Save Settings to apply changes.
Note: If you change the access point login password, you will need to access the
access point management page using the User Name “admin” and the new
password.
Change your device name
Main > Password
1. Log into your access point management page (see “
Access your access point
management page” on page 8).
To Next Page
Loading...
Need help?
General
