© Copyright 2015 TRENDnet. All Rights Reserved.
3. Once logged into the router’s user interface click Setup Wizard under Setup section
on the left side of the interface.
4. Click on Setup Wizard to start the setup wizard installation.
5. Select the mode provided by your ISP (Internet Service Provider) and click Next to
continue. The example below is based on PPPoE type with an ADSL connection type.
Please contact your ISP (Internet Service Provider) if you uncertain your connection
type. l
6. Select your connection mode and click Next.
7. Select Auto-detect to have the router automatically detect your encapsulation
information. Or simply select Manual Selection option to manually enter your VPI/VCI
settings. Click Next to continue.
9. Once the router detects your VPI/VCI settings, select your country and ISP services. If
your ISP services it not listed, select Other. If you selected Manual Selection on the
previous step, you will need to enter your VPI/VCI settings on this section.
10. Enter your assigned Username and Password information from your ISP (Internet
Service Provider). Click Next to continue.
To Next Page
Loading...
Need help?
General
