© Copyright 2015 TRENDnet. All Rights Reserved.
Destination/Source Netmask: Enter the destination and source network mask
address to apply on the queue.
Destination/Source Port Range: Enter the destination and source port to apply on
the queue.
Protocol: Select the protocol of the queue
VLAN ID: Enter the VLAN ID of the queue.
VLAN ID: If Default VLAN ID is not checked, enter the preferred VLAN ID.
DSCP: Select the DSCP mark.
Queue #: Select the queue to apply
DSCP Remark: Select the DSCP to apply
802.1p Remark: Select the queue remark to apply
Queue #: Select the queue to apply
Add static routes to your router
Advanced > Static Route
You may want set up your router to route computers or devices on your network to
other local networks through other routers. Generally, different networks can be
determined by the IP addressing assigned to those networks. Generally speaking and for
the case of an example, your network may have 192.168.10.x IP addressing and another
network may have 192.168.20.x IP addressing and because the IP addressing of these
two networks are different, they are separate networks. In order to communicate
between the two separate networks, static routing needs to be configured. Below is an
example diagram where routing is needed for devices and computers on your network
to access the other network.
Note: Configuring this feature assumes that you have some general networking
knowledge. Similar steps can be followed when applying IPv6 static routing rule.
1. Log into your router management page (see “Access your router management page”
on page 23).
2. Click on Advanced, and click on Static Route or IPv6 Static Route.
3. Review the settings and click Apply to save settings.
Destination IP: Enter the destination IP address.
Subnet Mask: Enter the subnet mask
Use Gateway IP Address: Enter the gateway IP address.
User Interface: Select the interface for the rule.
To Next Page
Loading...
Need help?
General
