© Copyright 2015 TRENDnet. All Rights Reserved.
In the diagram below, the blue color represents the WDS wireless bridged connections
between the routers. The green color represents access point mode connections
between wireless client devices and the routers.
.
Access Control Filters
Access control basics
Wireless MAC address filters
Advanced > Advanced Wireless > Wireless MAC Filter
Every network device has a unique, 12-digit MAC (Media Access Control) address. Using
wireless MAC filters, you can allow or deny specific wireless clients using this router’s
wireless network.
1. Log into your router management page (see “Access your router management page”
on page 23).
2. Click on Advanced, click on Advanced Wireless, and click on MAC Filtering.
3. Review the settings and click Apply to save settings and Add to enter MAC addresses.
Name (SSID): Select the SSID or wireless network name you would like to apply the
wireless MAC filter rule.
Access Control Mode: Select restriction type to use.
MAC: Enter the MAC address to apply the rule. Click Add to add MAC address to
select rule.
Comment: Enter any notes you would like to help distinguish the device.
Note: Any unspecified MAC/IP addresses or entries without the Allow option
checked will be denied network access.
MAC address filters
Every network device has a unique, 12-digit MAC (Media Access Control) address. Using
MAC filters, you can allow or deny specific computers and other devices from using this
router’s wired or wireless network.
1. Log into your router management page (see “Access your router management page”
on page 23).
2. Click on Advanced, click on Parental Control, and click on MAC Filter.
3. Select the type of Mac filtering option to enable.
Black List: Deny clients listed on the Mac address table to connect.
White List: Allows clients listed on the Mac Address table to connect.
To Next Page
Loading...
Need help?
General
