Triumph Sprint GT User Manual

40
General Information
Whenever the side stand is used before
riding, always ensure that the stand is fully up
after first sitting on the motorcycle.
For instructions on safe parking, refer to the
'How to Ride the Motorcycle' section.
Center Stand
1. C e n t e r s t a n d
2. Lifting handle (Sprint ST shown,
Sprint GT similar)
To set the motorcycle up on the center stand,
step down firmly on the foot-finder part of
the stand, then lift the motorcycle up and to
the rear using the lifting handle as a
handhold.
For instructions on safe parking, refer to the
'How to Ride the Motorcycle' section.
Lifting Handle
The lifting handle is located on the left hand
side of the motorcycle, and is the upper edge
of the pillion footrest hanger.
Always use the lifting handle or grab rail to
park the motorcycle on the center stand.
1
2
ccpo
Warning
Do not use the side panel or seat as a
hand-hold when placing the motorcycle on
the center stand as this will cause damage.

Triumph Sprint GT Specifications

General

Engine Type	Liquid-cooled, 12 valve, DOHC, in-line 3-cylinder
Displacement	1050 cc
Bore x Stroke	79 x 71.4 mm
Compression Ratio	12.0:1
Fuel System	Multipoint sequential electronic fuel injection
Final Drive	X ring chain
Clutch	Wet, multi-plate
Gearbox	6-speed
Front Tyre	120/70 ZR17
Rear Tyre	180/55 ZR17
Fuel Tank Capacity	20 litres
Max Power	130 PS (95.6 kW) @ 9, 200 rpm
Max Torque	108 Nm @ 6, 300 rpm
Exhaust	Stainless steel 3 into 1
Frame	Aluminium beam
Front Suspension	43mm
Rear Suspension	Monoshock with adjustable preload and rebound damping
Front Brakes	Twin 320 mm floating discs, Nissin 4-piston calipers
Rear Brakes	Single 255mm disc, Nissin 2-piston caliper
Seat Height	815mm
Ignition	Digital inductive type
Swingarm	Single-sided, aluminium alloy
Wheelbase	1, 537 mm