Triumph Sprint GT User Manual

94
Maintenance and Adjustment
Steering/Wheel Bearings
Steering Inspection
Lubricate and inspect the condition of the
steering head (steering) bearings in
accordance with scheduled maintenance
requirements.
Note:
• Always inspect the wheel bearings
at the same time as the steering
bearings.
Inspecting the Steering (Steering
head) Bearings for Free Play
Position the motorcycle on level ground, in an
upright position.
Raise the front wheel above the ground and
support the motorcycle.
Standing at the front of the motorcycle, hold
the lower end of the front forks and try to
move them forward and backward.
If any free play can be detected in the
steering (steering head) bearings, ask your
authorized Triumph dealer to inspect and
rectify any faults before riding.
Remove the support and place the
motorcycle on the side stand.
Warning
To prevent risk of injury from the
motorcycle falling during the inspection,
ensure that the motorcycle is stabilized and
secured on a suitable support. Do not
exert extreme force against each wheel or
rock each wheel vigorously as this may
cause the motorcycle to become unstable
and cause injury by falling from its support.
Ensure that the position of the support
block will not cause damage to the sump.
Warning
Riding the motorcycle with incorrectly
adjusted or defective steering (steering
head) bearings is dangerous and may
cause loss of motorcycle control and an
accident.

Triumph Sprint GT Specifications

General

Engine Type	Liquid-cooled, 12 valve, DOHC, in-line 3-cylinder
Displacement	1050 cc
Bore x Stroke	79 x 71.4 mm
Compression Ratio	12.0:1
Fuel System	Multipoint sequential electronic fuel injection
Final Drive	X ring chain
Clutch	Wet, multi-plate
Gearbox	6-speed
Front Tyre	120/70 ZR17
Rear Tyre	180/55 ZR17
Fuel Tank Capacity	20 litres
Max Power	130 PS (95.6 kW) @ 9, 200 rpm
Max Torque	108 Nm @ 6, 300 rpm
Exhaust	Stainless steel 3 into 1
Frame	Aluminium beam
Front Suspension	43mm
Rear Suspension	Monoshock with adjustable preload and rebound damping
Front Brakes	Twin 320 mm floating discs, Nissin 4-piston calipers
Rear Brakes	Single 255mm disc, Nissin 2-piston caliper
Seat Height	815mm
Ignition	Digital inductive type
Swingarm	Single-sided, aluminium alloy
Wheelbase	1, 537 mm