Triumph Sprint GT User Manual

80
Maintenance and Adjustment
Coolant Level Inspection
1. Expansion tank
2. MAX mark
3. MIN mark
Position the motorcycle on level ground and
in an upright position. The expansion tank is
located beneath removable panels on the left
hand side of the front fairing.
The coolant level in the expansion tank can
be checked by looking up and through the
center opening of the front fairing. The level
can also be checked from above by looking
down to the left.
Check the coolant level in the expansion
tank. The coolant level must be between the
MAX and MIN marks. If the coolant is below
the minimum level, the coolant level must be
adjusted.
Coolant Level Adjustment
1. Upper infill panel
2. Lower infill panel
3. Expansion tank
4. Tank cap
Allow the engine to cool.
Remove the two fasteners, release the upper
infill panel bayonet from the grommet and
carefully remove the infill panel.
Remove the fastener and carefully remove
the lower (fairing) infill panel to expose the
expansion tank.
ccno
2
1
3
Warning
Do not remove the expansion tank or
radiator pressure cap when the engine is
hot. When the engine is hot, the coolant
inside the radiator will be hot and also
under pressure. Contact with this hot,
pressurized coolant will cause scalds and
skin damage.
ccob
1
2
4
3

Triumph Sprint GT Specifications

General

Engine Type	Liquid-cooled, 12 valve, DOHC, in-line 3-cylinder
Displacement	1050 cc
Bore x Stroke	79 x 71.4 mm
Compression Ratio	12.0:1
Fuel System	Multipoint sequential electronic fuel injection
Final Drive	X ring chain
Clutch	Wet, multi-plate
Gearbox	6-speed
Front Tyre	120/70 ZR17
Rear Tyre	180/55 ZR17
Fuel Tank Capacity	20 litres
Max Power	130 PS (95.6 kW) @ 9, 200 rpm
Max Torque	108 Nm @ 6, 300 rpm
Exhaust	Stainless steel 3 into 1
Frame	Aluminium beam
Front Suspension	43mm
Rear Suspension	Monoshock with adjustable preload and rebound damping
Front Brakes	Twin 320 mm floating discs, Nissin 4-piston calipers
Rear Brakes	Single 255mm disc, Nissin 2-piston caliper
Seat Height	815mm
Ignition	Digital inductive type
Swingarm	Single-sided, aluminium alloy
Wheelbase	1, 537 mm