Troxler 3430 - Page 44

3-16
where:
WD = Wet density in kg/m
3
or pcf
DD = Dry density in kg/m
3
or pcf
%PR = Percent Proctor (This value is valid only if an
appropriate target has been entered for the material
being tested.)
MOIST = Moisture value in kg/m
3
or pcf
% MOIST = Percent moisture
Air Void = See description below
Void Ratio = See description below
MOIST CR = Moisture count ratio
DENS. CR = Density count ratio
M Count = Moisture counts as read by the gauge
D Count = Density counts as read by the gauge
xxxxx PCF
xx.x %
DD:
%PR:
xxxxx PCF
xx.x %
Moist:
% Moist:
xx.x%
Air Void:
Void Ratio
MOIST CR: xx.x
DENS CR: xx.x
M Count: xxxxx
D Count: xxxxx
(Use ↑ & ↓ keys)
PCF
WD: xxxxx