EASE OF OPERATION
The Model 5850v2 is calibrated and ready to use upon arrival. The
unit will compact asphalt samples to a specific height or a specific
number of gyrations, as selected by the operator. The angle of
gyration is recorded with every gyration, assuring angle stability.
As selected by the operator, the Model 5850v2 provides a
compaction pressure of 200 to 1000 kPa and an angle of gyration
between 0.00 and 1.50 degrees. Angle and pressure adjustments can
be performed quickly and easily using the keypad.
For ease of operation, the Model 5850v2 provides a fully automatic
method of compaction. The Model 5850v2 compacts an asphalt
specimen at the touch of a single key.
NOTE
Do not attempt to operate the Model 5850v2 before
reading this manual and the safety warnings posted on
the unit. Troxler stresses that the operator is solely
responsible for ensuring the safe use of the Model
5850v2. The manufacturer, its subsidiaries, distributors,
or representatives cannot assume responsibility for any
mishaps, damage, or personal injury which may occur
from failure to observe the safety warnings in this
manual and posted on the unit.
The Model 5850v2 can be equipped with 150-mm, 100-mm, or 4-
inch diameter molds, and can compact specimens with heights of up
to 185 mm.
The Model 5850v2 features USB and serial ports for transferring
data to USB or serial devices. The operator may choose to
automatically send the compaction data to a computer, printer, or
USB device upon completion of a compaction cycle.
NOTE
A list of USB memory devices and printers that are
compatible with the Model 5850v2 Gyratory Compactor
is available on the 5850v2 product page of the Troxler
website (www.troxlerlabs.com).
To Next Page
Loading...