SITE SELECTION
After unpacking and inspecting the compactor as described in the
previous sections, select a suitable site for installation. Apply the
following criteria in selecting the installation site:
Place the compactor on a flat, level location.
Locate the compactor no more than 1.2 m (4 ft) from the
required electrical power source (see Appendix C). Ensure that
the distance does not place stress on the power cord. The power
source must be wired by a qualified electrician.
The power switch is located on the left side panel, as shown in
Figure 1–1. Ensure that the placement of the compactor
provides easy access to the power switch.
To Next Page
Loading...