Troxler 5850v2 - Figure 4-2. Puck Centered on Lower Carriage Plate

Model 5850v2 4–7
4. CALIBRATION
1
1
.
.
Place the lower puck, larger edge down, in the center of the
lower carriage plate as shown in Figure 4–2.
2
2
.
.
Place the calibration load cell in the center of the puck as shown
below.
3
3
.
.
Place the upper puck, larger edge down, centered on top of the
load cell.
4
4
.
.
Route the load cell cables through the notch in the upper center
of the chamber opening as shown in Figure 4–3. Close the
chamber door.
Figure 4–2. Puck Centered on Lower Carriage Plate
PUCK
LOWER
CARRIAGE PLATE
LOAD
CELL