Troxler 5850v2 - Replacing the Batteries

Model 5850v2 Appendix A–7
A. TROUBLESHOOTING
REPLACING THE BATTERIES
The compactor uses two AA batteries to maintain the real-time
clock (date and time). To avoid loss of the real-time clock settings,
replace the batteries at least once a year.
WARNING
Carefully note the polarity of the batteries when
installing them in the battery holder. A battery may
explode or leak if installed improperly.
The battery holder is located behind the control panel. To replace
the batteries:
1
1
.
.
Turn the power switch off and disconnect the ac power cord
from the left side connector (see Figure 1–1 on page 1–7).
2
2
.
.
Remove the four screws that secure the control panel.
3
3
.
.
Carefully remove the control panel, using care not to damage
any of the cables connected to it.
4
4
.
.
The battery holder is located on the rear of the control panel.
Note the polarity of the AA batteries.
5
5
.
.
Remove the old batteries and install new AA batteries.
NOTE
If the new batteries are installed within approximately
one minute after the old ones are removed, the real-time
clock settings should be maintained.
6
6
.
.
Install the control panel using the four screws removed in
step 2.
7
7
.
.
Reconnect the ac power cord and turn the power switch on.
8
8
.
.
Verify that the compactor displays the current date and time.
Reset, if necessary, as described on page 5–3.