1–8
PARTS AND ACCESSORIES
The Model 5850v2 includes the electrical and mechanical parts
required to continuously compact hot-mix asphalt. Use Figure 1–1
to locate and identify the following parts:
The power switch is located on the left side of the compactor.
The emergency stop switch stops all machine movement.
The keypad and display provide the interface.
The mold (not shown) with the lower puck inserted receives the
asphalt for making specimens. Troxler offers molds with inside
diameters of 150 mm, 100 mm, and 4 inches. (Part numbers
116066 and 116069)
The USB and serial ports enable the operator to print or
download data to a USB or serial device.
The USB cable (not shown) connects the compactor to the
printer or other USB device. (Part number 110697)
The serial cable (not shown) connects the compactor to a serial
device, such as a computer. (Part number 106514)
The extruder is used to remove a compacted specimen from the
mold.
The cooling table is used to the compacted specimen.
The height standard assembly (not shown) is used to calibrate
the specimen height. (Part number 106989)
The Model 5850v2 Manual of Operation and Instruction (not
shown) provides the operating instructions for the compactor.
The printer (not shown) allows the operator to print data. (Part
number 116220)
The specimen papers (not shown) prevent the asphalt specimen
from sticking to the puck and ram head. (Part number 106953)
The optional Pressure Verification Kit (not shown) allows the
operator to verify the pressure calibration. The pressure is
initially calibrated at the factory. (Part number 108706)
To Next Page
Loading...