Troxler 5850v2 - Assembly; Figure 1-2. Hydraulic Reservoir

1–12
ASSEMBLY
1
1
.
.
The hydraulic reservoir is filled with a premium quality, light
grade (ISO VG 32, SAE 10) hydraulic oil prior to shipping.
Before using the compactor, check the oil level as follows:
a
a
.
.
Remove the rear service panel from the compactor.
b
b
.
.
Locate the fill level sight glass as shown in Figure 1–2.
NOTE
Use only a light grade (ISO VG 32, SAE 10, Troxler part
number 018203) hydraulic oil to fill the hydraulic
reservoir.
2
2
.
.
Ensure that the oil level is at the 30-degree mark on the sight
glass, as shown in Figure 1–3. If oil is needed:
a
a
.
.
Remove the reservoir fill cap (see Figure 1–2) and place a
funnel into the fill tube as shown in Figure 1–4.
b
b
.
.
Add oil until the level is at the 30-degree mark.
c
c
.
.
Remove the funnel and replace the reservoir fill cap.
d
d
.
.
Re-install the rear service panel.
Figure 1–2. Hydraulic Reservoir
RESERVOIR
FILL CAP
FILL LEVEL
SIGHT GLASS