Troxler 5850v2 - Page 24

1–14
3
3
.
.
Following the site selection guidelines in the previous section,
set the compactor in place.
4
4
.
.
Lock the casters so that the unit remains in place.
5
5
.
.
Plug the ac power cord into the ac power inlet on the
compactor’s lower left panel (see Figure 1–1 on page 1–7).
6
6
.
.
Connect the ac power cord to the required ac power source
(refer to Appendix C).
NOTE
On 240 VAC units, a connector must be installed on the
ac power cord. The connector must meet local safety and
electrical code requirements. Refer to the Electrical
Specifications section on page C–3 for the current and
voltage ratings for the compactor.
7
7
.
.
If using the compactor with a USB printer or memory device,
connect the device to the USB port located on the upper left side
of the compactor (see Figure 1–1 on page 1–7).
NOTE
A list of USB memory devices and printers that are
compatible with the Model 5850v2 Gyratory Compactor
is available on the 5850v2 product page of the Troxler
website (www.troxlerlabs.com).
8
8
.
.
If using the compactor with a computer, use a serial cable to
connect the computer to the serial port located on the upper left
side of the compactor (see Figure 1–1 on page 1–7).