the desired ram pressure (200 to 1000 kPa)
Set the desired gyration angle (0.00 to 1.50 degrees)
Before using the compactor for the first time, ensure that these
options are set properly. Press SETUP on the keypad to access
the Setup menu:
-Setup-
1- View Settings
2- Change Settings
3- Data Output
Press 1 to access the View Settings selection. The compactor
displays:
Selected run count (number of gyrations)
Selected mode (number of gyrations or specimen height)
Specimen height
Gyration angle
Ram pressure
Mold diameter
Gyrate Delay
Refer to Chapter 3 for instructions on changing any of these
selections.
The Model 5850v2 also provides numerous options for
automatically outputting or printing data following a compaction
cycle. The compactor can send the data to a computer or serial
printer via the serial (RS-232) port, or to a USB printer or memory
device (thumb drive) via the USB port.
NOTE
To Next Page
Loading...