3–10
DATA OUTPUT
The Model 5850v2 provides numerous options for outputting or
printing data. Compaction data can be printed manually from the
compactor’s memory or automatically upon completion of a
compaction cycle.
The compactor can send the data to a computer or serial printer via
the serial (RS-232) port, or to a USB printer or memory device
(thumb drive) via the USB port.
NOTE
A list of USB memory devices and printers that are
compatible with the Model 5850v2 Gyratory Compactor
is available on the 5850v2 product page on the Troxler
website (www.troxlerlabs.com).
The output data can be presented in either a height-versus-gyration
or full table format. These options are described on page 3–12.
NOTE
Before outputting data to a printer or computer, ensure
that the Model 5850v2 is properly connected to the
output device.
To configure the data output options, press 3 from the Setup
menu (see page 3–2). The compactor displays the Data Output
menu shown below. Use the arrow keys to scroll through the menu
options. To select an option, press the numeric key that corresponds
to desired option. The following sections describe each selection.
-Data Output-
1- Output Record
2- Auto Output
3- Output Device
-Data Output-
4- Output Format
To Next Page
Loading...