3–12
OUTPUT DEVICE
The compactor can send the data to a computer or serial printer via
the serial (RS-232) port, or to a USB printer or memory device
(thumb drive) via the USB port. To select the destination for the
output data, press 3 from the Data Output menu shown on page
3–10. The compactor displays:
-Output Destination-
1- Serial Port
2- USB Printer
3- Thumb Drive
Press the numeric key that corresponds to the desired output
destination. The compactor displays a brief confirmation message
and returns to the Output Destination menu. Press ESC to
return to the Data Output menu.
The GyroImport software is used to convert the data on the USB
memory device to a Microsoft Excel workbook. The software may
be downloaded from the 5850v2 product page on the Troxler
website (www.troxlerlabs.com) or it can be requested from
Customer Service at 1-877-TROXLER.
OUTPUT FORMAT
The Model 5850v2 outputs data in a height-versus-gyration format,
similar to the one shown in Figure 3–1, and shows the specimen
height, or thickness, for each gyration during a compaction cycle. A
full table output includes specimen height, gyration angle, ram
pressure, and shear stress (if enabled) for each gyration.
To print the output data, press 4 from the Data Output menu
(shown on page 3–10). The compactor displays:
-Output Format-
1- Table
2- Formatted
3- GyroPave
To Next Page
Loading...